Adding insulation or windows with your heat pump? How Ontario's energy assessment rebates work
Home Renovation Savings also pays for insulation, windows, doors and air sealing, but through a separate stream that needs a home energy assessment before any work starts. Here is what it pays and the order of steps.
A heat pump is not the only upgrade Ontario's rebate program pays for. If you also plan insulation, windows or doors, those sit in a separate stream with its own rules. Here is how it works, from the official pages.
Two streams in one program
Home Renovation Savings is brought to you by Enbridge Gas and Save on Energy. It is the program open now, and the one our rebate estimates use.
- Heat pumps. A home energy assessment is not required.
- Heat pump water heaters, windows, doors, insulation and air sealing. These need a home energy assessment before any work begins. You must install at least two of these upgrades to qualify.
The help page lists what counts as a qualified upgrade in this stream: air sealing, attic, wall, basement, exposed floor and crawl space insulation, windows and doors, and a domestic hot water heat pump. A space heating heat pump is not on that list.
What the assessment stream pays
The program page lists these rebates.
- Attic insulation: up to $1,500
- Foundation insulation: up to $2,300
- Exterior wall insulation: up to $3,600
- Exposed floor insulation: $300
- Windows and doors: $100 per rough opening
- Air sealing: up to $250
- Heat pump water heaters: $500
You pay for the assessments up front. To offset that cost, you receive a $600 rebate after successful completion of the program. It is available once per participant, per home.
Complete three qualifying upgrades and you get an additional $500. The help page says this applies with a post-renovation assessment date on or after January 5, 2026.
The order of steps
- Assessment first. Before any work, get a list of Service Organizations from the program and complete an initial home energy assessment. It takes about two hours.
- Read your report. It shows which upgrades are recommended for your home. Choose at least two.
- Do the work. Your preferred contractor completes it. You must hire a professional contractor for windows, a heat pump water heater or insulation. Air sealing can be do-it-yourself.
- Follow-up assessment. Complete it with the same registered energy advisor. It takes about an hour.
- Rebate. Once the advisor submits the documents, expect it within 60 days by cheque, or within 30 days by Interac e-Transfer.
The program recommends choosing air sealing as your third upgrade or later, because the home must meet an air tightness target.
If you already started
If you already installed or started these upgrades, you are not eligible for the bundled rebates. The help page says you may still be eligible for upgrades that need no assessment, including a heat pump.
The heat pump keeps its own rules. You must work with a participating contractor, and pre-approval is mandatory. Installations done before approval are not eligible.
The federal rebate is separate
The National Heat Pump Rebate is a federal program, expected to launch in early 2027. Canada.ca describes it as having no energy audit required before or after installation. Installs from November 1, 2026 may be eligible. Households above the median income may be eligible for $2,000, and households below it for up to $10,000. The page says program parameters and eligibility criteria are still being finalized and may change.
Our rebates guide explains both programs. You can check your heat pump rebate for free on the home page and ask for a free quote there.
This post is based on this article.